Manley MONO & DUAL MONO TUBE DIRECT INTERFACE MODELS Manual do Utilizador

MANLEYLABORATORIES, INC.OWNER'S MANUALMONO & DUAL MONOTUBE DIRECTINTERFACE MODELSMANLEY LABORATORIES, INC.13880 MAGNOLIA AVE.CHINO, CA. 917

WARRANTYAll Manley Laboratories equipment is covered by a limited warranty against defects inmaterials and workmanship for a period of 90 days from

WARRANTY REGISTRATIONWe ask that you please fill out this registration form and send the bottom half to:MANLEY LABORATORIESREGISTRATION DEPARTMENT1388

CONTENTSINTRODUCTION 3CONNECTING YOUR TUBE DIRECT 4FIGURE 1 FRONT PANEL 5FIGURE 2 REAR PANEL 6OPERATIONAL NOTES POWER 7TUBE LIFEINPUT EQ SELECTAPPLICA

INTRODUCTIONWATER & MOISTUREAs with any electrical equipment, this unit should not be used near water or moisture.SERVICINGThe user should not att

CONNECTING YOUR DIRECT INTERFACE1. Be certain that the unit is switched off.2. Connect the supplied IEC Mains Cable to the IEC receptacle on the rear

FRONT PANEL A B C D E FBASS FULLBASS MEDIUMGUITAR / SYNTHGUIT

REAR PANEL A B C DA IEC MAINS SOCKET Standard IEC mains socket

OPERATIONAL NOTESPOWERIt is not recommended that you leave your Tube-Direct Interface permanently switched on. Thisonly wastes electricity and tube

CONNECTIONS DI's can be patched into several places in the chain. The most common and mostuseful is between the instrument and amplifier - The a

3) Return the signal to a mic pre. Manley Tube mic pre is prefered of course.4) EQ - Roll off the top end somewhere between 6kHz and 10kHz, boost 40