Manley ELECTRO-OPTICAL LIMITER - 1997 - 9/2000 MELOPB319 Manual do Utilizador

OWNER'S MANUALMANLEYELECTRO-OPTICALLIMITERMANLEY LABORATORIES, INC.13880 MAGNOLIA AVE.CHINO, CA. 91710TEL: (909) 627-4256FAX: (909) 628-2482emai

TROUBLE-SHOOTINGThere are a number of possible symptoms of something not quite right, some may be interfacing, others we will touchon as well. The pre

IT MAKES NOISES WHEN THE FRONT PANEL IS TAPPED - An easy one. Some tubes become microphonic overtime. That means they start acting like a bad micropho

INTERNAL ADJUSTMENTS664141) You will have to start out by setting front panel controls to these settings. BYPASS mode, SEP (LINK OFF ), REDUCTION cont

13SPECIFICATIONSMaximum Input (Bypass through Line Amplifier) +30 dBv(with Limit "IN" the maximum is entirely variable)Maximum Output +30 dB

WARRANTYAll Manley Laboratories equipment is covered by a limited warranty against defects in materialsand workmanship for a period of 90 days from

WARRANTY REGISTRATIONWe ask that you please fill out this registration form and send the bottom half to:MANLEY LABORATORIESREGISTRATION DEPARTMENT1388

CONTENTSSECTION PAGEINTRODUCTION 3FRONT PANEL 4REAR PANEL 5OPERATION NOTES 6 & 7ADVANCED TRICKS 8MAINS CONNECTIONS 9TROUBLE SHOOTING 10 &

INTRODUCTION!THANK YOU!...for choosing the Manley Stereo Electro-Optical Limiter. This Limiter follows in the tradition of thevintage LA-2A Leveling A

FRONT PANELA REDUCTION. Adjusts the amound of limitng in the that channel. This could also be calledThreshold. Turning this clockwise introduces limi

REAR PANELACDBFEGIHJ5A 1/4" INPUT (UNBALANCED) (RIGHT) TIP: HOT SLEEVE: GROUNDB XLR INPUT (BALANCED) (RIGHT) PIN 1: GROUNDPIN 2: HOT (+)PIN 3

6OPERATION NOTESTheManley Electo-Optical Limiter follows certain traits and traditions established by the UREILA-2 and similar levelling amplifiers. T

The slope or ratio is also difficult to simulate. The initial ratio is low and becomes higherwith more gain reduction until the leds light up fully an

Advanced TricksHere are a few tricks that are not really for rookies. They come from guys doing major records for yearsand won't work unless you&

MAINS CONNECTIONSYour Limiter has been factory set to the correct mains voltage for your country. The voltagesetting is marked on the serial badge, l